Documenti tecnici
Documenti tecnici
Results of ISO/TS 6336-22 Evaluating Full Contact Zone
Description of ISO/TS 6336-22 The previous paper contained a detailed description of the methods in ISO/TS 6336-22. A brief […]
Documenti tecnici
Post-Process Superfinishing of Additively Manufactured Components for Next-Gen Space Application
REM Surface Engineering and Additive Manufacturing The past decades have seen Additive Manufacturing (AM) develop from an idea to a […]
Documenti tecnici
Case Study of ISO/TS 6336-22 Micropitting Calculation
ISO/TS 6336-22 (Calculation of load capacity of spur and helical gears — Part 22: Calculation of micropitting load capacity) is the ISO technical specification containing a proposal for a calculation for the risk of micropitting in gear sets.
Documenti tecnici
Report of the Condition of a General Electric Transportation Systems Gearbox
Wind power plant operation and maintenance (O&M) costs remain an appreciable contributor to the overall cost of wind energy, with a capacity-weighted average of $11/megawatt-hour (MWh) for projects installed since 2000 and $9/MWh for projects installed since 2010
Documenti tecnici
A Comparison of Surface Roughness Measurement Methods for Gear Tooth Working Surfaces
Surface roughness is a critical parameter for gears operating under a variety of conditions. It directly influences friction and contact temperature, and therefore has an impact on various failure modes such as macropitting, micropitting and scuffing.
Documenti tecnici
Surface Treatment of Powder-Bed Fusion Additive Manufactured Metals for Improved Fatigue Life
High-cycle fatigue (HCF) tests were conducted on samples fabricated by two powder-bed additive manufacturing techniques.
Documenti tecnici
AH-64 Loss of Lubrication Study: Test of Isotropic Superfinished AH-64 (Apache) Engine Nose Gearbox Without Black Oxide Coating
Rotorcraft gearboxes are designed to the utmost precision to withstand the tremendous demand and loads required to convert thousands of horsepower and RPM into hundreds of RPM and lift torque.
Documenti tecnici
Future Advanced Rotorcraft Drive System (FARDS) Full Scale Gearbox Demonstration
The Future Advanced Rotorcraft Drive System (FARDS) program focused on improving the performance and affordability of current aircraft drive systems.
Documenti tecnici
Gear Repair for Helicopters and Wind Turbines via Isotropic Superfinishing
The wind turbine, aerospace, and helicopter gear industries recognize the importance of surface finish and surface texture for maximizing component and system performance.
Documenti tecnici
Gear Corrosion During the Manufacturing Process
No matter how well gears are designed and manufactured, gear corrosion can occur that may easily result in catastrophic failure. Since corrosion is sporadic and a rare event and often difficult to observe in the root fillet region or in finely pitched gears with normal visual inspection, it may easily go undetected.
Documenti tecnici
High Speed, Automatable Superfinishing of Rear-Axle Hypoid Gears
The benefits gained by superfinishing rear-axle hypoid gearsets are now well documented. Friction, wear and operating temperature are significantly reduced. The main impediment to commercially implementing this process, however, is that it increases manufacturing cost in terms of process speed, work in process and labor.
Documenti tecnici
The Effect of Superfinishing on Gear Micropitting, Part II
It should be noted from the outset that the data presented in Part I and Part II of this paper was generated by independent laboratories. Superfinishing of the gears was the authors’ sole contribution to these studies.
