superfinishing

Mechanical Paste Polishing vs. CAVF Finishing of Gears

Posted by on lunedì, Agosto 3rd, 2020 in

Choosing the best gear finishing method often comes down to production volume, processing cycle times, and gear profiles. By William […]...

View More

The Challenges of Generic Deburring vs. CAVF Deburring

Posted by on domenica, Luglio 19th, 2020 in

CAVF allows use of HDNA media, which has a low attrition rate, keeping its shape and size much longer and […]...

View More

Metal Finishing for 3D Printed Parts Webinar – Part 8 – LATTICE BRACELET

Posted by on martedì, Luglio 7th, 2020 in

Metal Finishing for 3D Printed Parts While many can be put into operation as sintered, there are a number of […]...

View More

Metal Finishing for 3D Printed Parts Webinar – Part 7 – OPEN IMPELLER

Posted by on lunedì, Luglio 6th, 2020 in

Metal Finishing for 3D Printed Parts While many can be put into operation as sintered, there are a number of […]...

View More

Metal Finishing for 3D Printed Parts Webinar – Part 6 – SHOCK ABSORBER PISTON

Posted by on lunedì, Luglio 6th, 2020 in

Metal Finishing for 3D Printed Parts While many can be put into operation as sintered, there are a number of […]...

View More

Metal Finishing for 3D Printed Parts Webinar – Part 5 – FINGER SPLINTS

Posted by on lunedì, Luglio 6th, 2020 in

Metal Finishing for 3D Printed Parts While many can be put into operation as sintered, there are a number of […]...

View More

Metal Finishing for 3D Printed Parts Webinar – Part 4 – PARACHUTE RINGS

Posted by on lunedì, Luglio 6th, 2020 in

Metal Finishing for 3D Printed Parts While many can be put into operation as sintered, there are a number of […]...

View More

Metal Finishing for 3D Parts Webinar – Part 3 – GEARS

Posted by on lunedì, Luglio 6th, 2020 in

Metal Finishing for 3D Printed Parts While many can be put into operation as sintered, there are a number of […]...

View More

Materials Matter : Roughness Measurement: Optical vs. Contact Stylus Profilometry

Posted by on domenica, Aprile 19th, 2020 in

Optical profilometry will become an important tool for predicting gear performance with more research and development of an objective lens to fit into tooth spaces....

View More

Report of the Condition of a General Electric Transportation Systems Gearbox

Posted by on martedì, Aprile 14th, 2020 in

Wind power plant operation and maintenance (O&M) costs remain an appreciable contributor to the overall cost of wind energy, with a capacity-weighted average of $11/megawatt-hour (MWh) for projects installed since 2000 and $9/MWh for projects install...

View More

Rotorcraft Gearbox Regulations: LOL (not what you think)

Posted by on lunedì, Marzo 16th, 2020 in

The European Union’s CS-29 Amendment 7 places more stringent and rigorous testing requirements for certification of Category A type pressurized gearboxes under loss of lubrication conditions compared to the previous regulation....

View More

Roughness Measurement Tips: The Scratch Pad

Posted by on giovedì, Gennaio 16th, 2020 in

You can check a profilometer’s overall performance following a quality-control-defined procedure and frequency using this traceable calibration specimen. By Mark Michaud […]...

View More